Installation
First: Remove Chrome rings around bulbs then remove Seal Beam lamps then Cut Aluminum Nest to a larger hole .
Second : Cut the Bucket (behind seal beams) Below Low Beam both sides to allow projector to fit
Wiring
Connect: A - Power Cable to OEM Original Bulb Plug , Then into Ballast and into High Beam Flapper Plug on Low Beam Housing ,
Connect: the 9005 Halogen Bulb plug adapter in to OEM Plug
Wig Wag feature must be disabled and Reduced Voltage DRL Daytime Running Lights must be Disabled or use relay cable kit to attach to 12 v source , Ballast can't handle reduced voltage or pulsating voltage .
Connect: the 9005 Halogen Bulb plug adapter in to OEM Plug
Wig Wag feature must be disabled and Reduced Voltage DRL Daytime Running Lights must be Disabled or use relay cable kit to attach to 12 v source , Ballast can't handle reduced voltage or pulsating voltage .
RELAY for B-cable to supply full 12v to ballast if needed eliminated in new system
Newest Relay S11-1A-C1-12 30A /12VDC
|
Original 2 Relay HLS-4121-DC-12V 30A /12VDC
|
Original Relay 804-1A-C1 12VDC
30a /12VDC |
Pin view same on all versions
|
Schematics A , A1 , B , C


Bruce Chandler
www.BrightHeadlights.com
377 Rubin Center Dr. Suite 115
Ft. Mill, SC. 29708-7257
704-523-3548 office
704-564-3383 cell
704-525-0221 fax
Bruce@Datasyst.net
Since 2001
www.BrightHeadlights.com
377 Rubin Center Dr. Suite 115
Ft. Mill, SC. 29708-7257
704-523-3548 office
704-564-3383 cell
704-525-0221 fax
Bruce@Datasyst.net
Since 2001